How to cut repeat pattern wallpaper?

Putting up wallpaper can make a room look amazing, way better than just paint. But, to get it just right, especially with repeat patterns, you need to know how to cut the wallpaper properly. Here’s a simple guide to help you out!

What is Repeat Pattern Wallpaper?
Repeat pattern wallpaper has designs that repeat over and over. These patterns can be anything from simple shapes to fancy flowers. The trick is to make sure these patterns line up perfectly on your wall. This can be tricky but totally doable with the right steps!

What You’ll Need
Before you start, gather these tools:

Wallpaper rolls
Wallpaper paste or adhesive
Measuring tape
Straight edge or ruler
Utility knife or wallpaper scissors
Cutting mat
Pencil
Level
Seam roller
Measuring the Wallpaper
Measure Your Wall: Measure from the ceiling to the floor and add a few extra inches.
Check the Pattern Repeat: This tells you how often the design repeats. You’ll find this info on the wallpaper label.
For example, if the pattern repeats every 24 inches, cut your wallpaper in 24-inch segments to make sure the patterns match.

Cutting the Wallpaper
Lay it Out: Put your wallpaper on a cutting mat with the pattern side up.
Measure and Mark: Use your measuring tape and straight edge to mark the length you need.
Cut Carefully: Cut along the marked lines with your knife or scissors.
Hanging the Wallpaper
Apply Paste: Brush wallpaper paste on the back of the first strip.
Book the Wallpaper: Fold the pasted sides together and let it sit for a bit.
Use a Level: Draw a straight vertical line on the wall as a guide.
Hang the First Strip: Align the top with the ceiling and smooth it down, removing air bubbles as you go.
Aligning and Cutting More Strips
Paste and Align: Paste the next strip and line up the pattern with the first strip.
Smooth and Trim: Smooth the strip down and trim any extra at the top and bottom.
Tips for Perfect Wallpaper Cuts
Double-Check Measurements: Always measure twice!
Use Sharp Tools: Sharp knives or scissors make clean cuts.
Seam Roller: Use this to press down the edges so the seams are invisible.
Proper Adhesive: Use the right paste for your wallpaper type.
Take Your Time: Be patient and precise to avoid mistakes.
Troubleshooting
Pattern Misalignment: Peel back and adjust the strip if patterns don’t match.
Air Bubbles: Smooth out bubbles with a brush. If stubborn, prick with a pin and press out the air.
Overlapping Seams: Ensure seams are butted, not overlapping. Press them down firmly with a seam roller.
Conclusion
Cutting repeat pattern wallpaper needs precision and the right tools. Follow these steps to get a flawless look for your room. If you’re in Florida and need help, Wall Mastery is here to assist with expert wallpaper installation, making your walls look stunning!